Often happens the Engine is not running and when reaching to AT, we get a warning message as the attached picture shows. Adding a shortcut button in both areas as START ENGINE, rather than going to find and start engine separately can save time.
Thank you for your submission. We are currently reviewing this and I have a few additional questions :
Would you also like that the engine starts automatically when launching the Master ? Maybe have an applicaiton setting to enable / disable this behavior ?
If you start the engine from the Master I supsect you would expect the engine to start running on the project job queue, and not on the job queue that has been set with iTwin Capture Modeler settings (the two might be different). Is that correct ?
Thank you for your submission. We are currently reviewing this and I have a few additional questions :
Would you also like that the engine starts automatically when launching the Master ? Maybe have an applicaiton setting to enable / disable this behavior ?
If you start the engine from the Master I supsect you would expect the engine to start running on the project job queue, and not on the job queue that has been set with iTwin Capture Modeler settings (the two might be different). Is that correct ?