Currently iTwin Splats are terrible. My most recent splat does NOT align with the mesh or generated tie points which is strange, as I would assume the splats hang off the tie points! Pot Shot, Lixel, Nerf Studio are all producing better splat resu...
We need support to create a template as stated in the knowledge base. The data is all processed and already georeferenced and also appears in the table of supported file formats. Explicitly, these are outputs from the Pix4Dmatic software. https://...
When using multiple engines/computers for processing create the ability to pick which engines/computers to use/prioritise.
Our computers are left with the engines running so that we can process whenever we want and turned off - restarted weekly. The computers all have different processing power and we would like to choose the most powerful ones to perform the aerotria...
Red-green colour blindness affects approximately 8% of males and 0.5% of females globally. The shades of green, yellow/orange and red that represent good to bad solutions in the survey tab as well as the image frustums are very difficult to differ...
When adding images to a new block there is an option to modify between Sea Level or WGS 84 Ellipsoid. After modifying or not there is no place that it is stated what was selected. We wish to know what was selected in each block.
Often happens the Engine is not running and when reaching to AT, we get a warning message as the attached picture shows. Adding a shortcut button in both areas as START ENGINE, rather than going to find and start engine separately can save time.
When filling holes there is an error that shape is self-intersecting. Need a visual cue where the problem is found. Ceate some 5-10 holes and then try to close. At least 1 or 2 will have such issue. Hard to fix as it is not clear where to look for...
0
Needs review